3D carbon BLACK Car Vinyl Wrap 2D Carbon Fibre Sheet Film Sticker Car Wrap Air bubble free gloss
Automotive Vinyl Wraps Film
Estimated Delivery:
Jul 19 - Jul 23Free Shipping & Returns:
On all orders over $75The film is coated with a UV coating, Once applied and bonded to your surface you may clean it with any type of cleaning agent that is used for painted surfaces. The material is soft and highly flexible allowing it to conform to contours and bend easily. After applying the Vinyl Sheet, you simply trim the excess vinyl with a sharp blade or hobby knife (not included). What you have left is a customized look without the headaches and costs associated with spraying.
Made with automotive grade premium high quality cast vinyl that is used for wraps and conforms to the most challenging contours and shapes, Can be re lifted, repositioned and stretched before going over with a squeegee. When applied correctly to the appropriate hard surface the film is very durable.
Any creases/folds will come out with heating from hairdryer or heat gun, Will not harm painted surfaces. Can be easily repositioned during installation and does not leave adhesive residue behind, Grid pattern backing for more precise measuring and cutting.
Top quality German adhesive with built-in air channels for easy, bubble-free installation Extremely Flexible and can be applied to moderate curves or any smooth flat surface.
Coated with a UV protective layer, Durable material resistant to water, dirt, grease, salt, mild acid and oil Easily remove without residue, will not harm the painted surface of your vehicle.
-
You will need a heat gun , the optimum temperature reached during post-heating is 110-120C.
-
Make sure the vinyl is down securely in any recesses and channels.
-
Check that the vinyl hasn’t lifted in any areas, leaving pockets of air that will cause the film to burn when we apply heat.
-
If the film lifts as the temperature increases, it indicates that there is still air beneath the film. This air will expand, causing the film to lift and burn through.
-
Working on areas 8-10 inches wide, move your heat gun over the vinyl, until the required temperature is achieved. This may take some time, depending on the quality of your heat gun.
-
Repeat this process over all channels and recesses, being sure not to miss any small areas.
-
Then apply the same process to any trimmed edges and areas where the film has been overlapped.
-
Once post-heating has been completed, and you have inspected the vehicle for any imperfections, the vehicle needs to remain on your premises for the next 12-24 hours. This will allow the adhesive to harden, and the face stock to stabilize
