Frosted Window Film - Self Adhesive Etched Privacy Glass Vinyl Wrap Bubble Free

Frosted windows film is ideal for extra privacy. Easy to apply and remove can be used in kitchens, Bathrooms, Workshops, Office, Doors and Windows

Instructions

1. clean the surface with appropriate before installation spray some soapy or detergent onto the glass and clean it thoroughly, taking special attention        to the edges. Making sure spots,dirt,grease and residue are properly remove and resisting dirt such as dry paint found on the glassafter successful        cleaning please use an appropriate cloth to dry the glass surface leaving not traces of water . 

2. Using a tape mesure take some measurment of the window and write it down. Cut the film to the shape of slightly 1" larger than the actual size of          the  window surface being covered 

3. Use two pieces of adhesive tapes to separate the film from its protective liner backing whilst removing the backing of the film spray some soapy               water onto the adhesive surface of the firm. 

4. Spraye water on both the glass window and window fim then place the film ( Adhesive side facing the glass) onto the window being careful not to            crease the film adjust accordingly to cover the window glass surface perfectly. 

5. Use a small squeegee to burnish the film onto the window and pushing air bubbles to the edges with the help of squeegee star to remove someof 

    the water from behind the film start from the centre moving outwards . Do not worry if you have not managed to get rid of all the existing water. This        stage is to keep the film in place for cutting. 

6. Trim the edges of the film with a sharp utility knife to reach  a perfect fit to remove any remaining water spray more soap water over the film then             appyl minimal pressure using the squeegee to push the bubbles out repeat until all air bubbles are completely removed.

- Measure the Glass and cut out the film according to the measurement, the film must be 2cm longer than the actual size.

-Clean the glass.

-Peel off the paper but do not peel off the whole paper, only you have to peel off the beginning so that the beginning of the film can be pasted on the glass.

-Spray water to adhesive part while peeling off the release paper form the sheet-Past the film from top to bottom of the glass and peel off the paper slowly.

-Spray water to the window as the same way

-After pasting remove the air bubbles with squeegee like plastic  board, member ship card or bank card.
-If some air bubble can't be removed prick them with needle then smooth the film.
-after some hours cut out the unnecessary with knife