GLITTER BLACK Matt Vinyl Wrap Sheet Sticker Film Air bubble Free Car Wrap.

• This vinyl will give your vehicle a new look with a matte glitter Black finish . Can be used to wrap a section of your vehicle or the entire car body depending on your preference.
• Permanent acrylic pressure-sensitive adhesive
• can be re-lifted, repositioned and stretched
• Stretchable with heat
• Conform to contours and bends easily
• High temperature & water resistant
• can be washed with soap and water
• Stands up against water, dirt, grease, salt, mild acids
• Long life with excellent UV durability (up to 3 years)

Instructions

1.Cleaning the surface with rubbing alcohol prior to installing the vinyl will help with adhesion and clean any contaminants that may cause imperfections.
2.Using a heat gun can aid in the installation by making the vinyl more pliable and also help remove wrinkles.
3.Using a soft rubber squeegee will help smooth out bubbles and wrinkles
You will need a heat gun and an IR thermometer to accurately measure the temperature required for successful post-heating.
For Arlon Cast films, the optimum temperature reached during post-heating is 110-120C.
Make sure the vinyl is down securely in any recesses and channels.
Check that the vinyl hasn’t lifted in any areas, leaving pockets of air that will cause the film to burn when we apply heat.
If the film lifts as the temperature increases, it indicates that there is still air beneath the film. This air will expand, causing the film to lift and burn through.
Working on areas 8-10 inches wide, move your heat gun over the vinyl, until the required temperature is achieved. This may take some time, depending on the quality of your heat gun.
Repeat this process over all channels and recesses, being sure not to miss any small areas.
Then apply the same process to any trimmed edges and areas where the film has been overlapped.
Once post-heating has been completed, and you have inspected the vehicle for any imperfections, the vehicle needs to remain on your premises for the next 12-24 hours. This will allow the adhesive to harden, and the facestock to stabilize.